Schiedel ICID Plus 125mm Stainless Roof Terminal Kit

This Schiedel ICID Plus pack is a roof terminal component bundle — it is not a complete chimney system from stove to sky. It is for finishing above the roof where an anchor plate is the right Schiedel part: typically when starting from a fire chest, or when extending an existing brick or masonry chimney stack.

Diameter and finish: 125 mm internal flue diameter, stainless twin-wall components.

What is included

• 1 × anchor plate
• 1 × twin-wall pipe (about 960 mm / 1 m)
• 1 × aluminium angled roof flashing for a pitched roof of about 5–45°
• 1 × storm collar — sits on the flashing to weather the joint and shed rain
• 1 × raincap with bird mesh (keep this clear of soot; sweep regularly on solid fuel)
• 3 × locking bands

What is not included

• Appliance connector, stove-side flue, firestops or wall bands
• Flat-roof flashing (this pack is not for flat roofs)
• Flashings for pitches steeper than about 45°
• Flexible liner adaptors or a full height of twin-wall below the roof
• Structural fixings design beyond the anchor plate’s documented use

Important limits: The anchor plate is not a general-purpose “roof support for any twin-wall already at roof level”. Use it only where Schiedel specifies an anchor plate (fire chest or masonry stack extension). For flat roofs you need a flat flashing kit instead — not supplied here.

Please note: Installation must comply with Building Regulations and Schiedel’s ICID Plus instructions, by a competent person. This bundle does not mean the rest of the chimney or your stove is approved or complete.